|
I've been also patiently waiting. Reason there is no USA unlocks is due to the EPA... They'll crack down on it and give fines that one will never recover from.
There is rumors that Femto is actually owed by Bosch themselves... but it's just a rumor, if someone is going to eventually crack it why not have the manufacturer provide an unlock for now while monetizing.
I'm currently running a JB4 on Map 2 with 2.5 gallons of E85 per fill up.
I do have water meth injection from Burger using their intercooler nozzle adapters on the balance tube and FSB controller. But running small BM7 nozzles as I just want it for the cooling benefit here in Texas summers.
Don't really want to rely on WMI supplementing fuel for HP.
I have full catless downpipes, res delete, dinan inlets and BMC filters.
It's a 22' Gran Coupe Comp with a bit extra weight (21" wheels and Sound system)
Car ran a 10.71 @132 with the JB4 on Map 2 on straight 93 no E mix, no launch control.
It's probably a 10.5X @133-134 car with E20 mix and using launch control with the JB4, but that's really as best as it gets as I don't really like the fact that it fools the IAT's to pull timing.
BUT I FINALLY GAVE IN
My DME's are coming back from Femto now as I type this, they should be here tomorrow.
I shipped them Monday from (Houston, TX) using a DHL Express trailer - They offer 50% off if you use their express trailer locations. Just tell them to use code "Green50" lol. So I paid $140.
I'm about $1960 in with shipping and the cost of the unlock to femto.
+$895 for BM3 license (15 % off if I buy from ABP)
+$1050 for a custom tune.
So this is the timeline:
-Shipped Monday @1PM from Houston TX
-Delivered to Femto Wednesday
-Femto shipped back the same day
-Arrives Friday according to DHL.
So all in all.... 5 days. Pretty impressive.
Main reasons I did it is because I absolutely hate the clapped out sound it makes during cold starts. So I want to disable that.
& I hate having to clear the CEL every 2-3 engine start cycles just so I can remote start.
I'll be getting tuned by ABP (AB Performance) using BM3.
Getting 2 maps
-E40 blend + WMI
-93 oct. + WMI
They have dozens of setups surviving 800whp since he limits torque at low RPM's to keep the connecting rods happy.
Made lots of research on who I'm going with for my tune, so I was debating between the following
-Grigory: Tunes the worlds fastest M5 and M8 from Freehouse but there will be a language barrier.
-HCP: Lots of fast E40 M5/M8's with healthy torque curves but they just have lots of channels... Like HCP.US, HCP.Brazil etc. so unsure which tuner I'll be getting.
-Utkunoa: Well rounded tuner but can be busy, usually leaves them more on the tame side.
-Stimkey: (mostly a B58/S58 tuner) - Holds B58/S58 records
-Pureboost: Good results and good prices. Would just like someone more dedicated to the S63TU engine.
Also have an xHP stage 3 trans tune, but will be getting custom settings from ABP.
|