[snareman]

Originally Posted by MACHT

Well there's actually more to fully enable anti-dazzle:

BDC Body Domain Controller LUT_AFS_CODRV_HOR standard/init
BDC Body Domain Controller LUT_AFS_DRV_HOR F040_G005_AHL...
BDC Body Domain Controller LUT_FLC_FORWARDLIGHTING_Y AFS
BDC Body Domain Controller C_AFS_ENA aktiv
BDC Body Domain Controller C_AFS_ECO_LEVEL_3_ENA enable (1)
BDC Body Domain Controller C_HBA_ENA aktiv
BDC Body Domain Controller C_HBA_DIM_ENA enable (1)
BDC Body Domain Controller C_HBA_GFHBA_ENA_V_HI standard (3C)
BDC Body Domain Controller C_HBA_GFHB_ENA aktiv
BDC Body Domain Controller C_CLC_CURV_V2 ECE (23)
BDC Body Domain Controller C_CLC_CURV_V3 ECE (28)
BDC Body Domain Controller C_CLC_EXT_ENA enable (1)
BDC Body Domain Controller C_FLC_ENA aktiv
BDC Body Domain Controller C_BLC_PRE_ENA enable (1)

This is only accessable via ProTool:

KAFAS4 3100 COMMON COUNTRY_VARIATION Europe_RC [01]
KAFAS4 3102 LIGHT DETECTION C_FLA_CC_MESSAGE_3 no_CC_message [00]
KAFAS4 3102 LIGHT DETECTION C_FLA_COUNTRY_WITH_MULTIPLE_REFLECTORS active
KAFAS4 3102 LIGHT DETECTION C_FLA_US_SENSITIVITY_MODE normal [0]
KAFAS4 3102 LIGHT DETECTION C_FLA_BS_ENTER_THRESH Rest of world [03)
KAFAS4 3102 LIGHT DETECTION C_FLA_BS_EXIT_THRESH Rest of world [02]

Right so my question is how different the result is between the two because seems like there was a ton of settings to change if you were doing it the real way and I'm only changing one thing with Bimmercode